How do modern dishwashers take way longer to run and clean better yet use less energy and water?

225 views

How do modern dishwashers take way longer to run and clean better yet use less energy and water?

In: 8487

11 Answers

Anonymous 0 Comments

The vast majority of the energy that a dishwasher uses goes towards heating the water. The sprayer pumps use very little power in comparison.

So the best way to reduce the overall energy consumption is to lower the water temperature, which makes the cleaning cycle take longer, but that’s fine because only the low power pumps are running during that time.

edit: The same idea applies to washing machines, by the way.

Anonymous 0 Comments

Also a huge improvement in modern dishwashers is the design. Most of the old crap is either plastic or metal with nearly zero insulation. Modern dishwashers are typically steel tube with a rubber tar like layer melted onto it, and then also come with actual insulation on the outside to aid in heat loss reduction. Also keeps the noise down better.

Next is by design it uses less water, which is good. However the old gel dishwasher detergent is extremely bad, as water saving units do not drain enough water to get that gel crap out of your drain lines, which in term causes pump failure. Only use pods or powder.
Edit, I mean pods which have a small amount of gel, and the rest are powder. Thought I should clarify.

Fun fact, dishwashers use about the same amount of water in 2-3 minutes of washing by hand.

Anonymous 0 Comments

It’s all to do with efficiency, newer models are more efficient but run slower, heat less water at lower temps (sometimes)
Think of a car doing 100mph, it would take 1 hour to go 100miles and say it burns 5 gallons of fuel (20 mpg)

If the car ran at 50mph it would take 2 hours but might get 40mpg so would only use 2.5 gallons.

Same job done, it took longer but was cheaper.

Anonymous 0 Comments

[removed]

Anonymous 0 Comments

[removed]

Anonymous 0 Comments

Heating the water takes much more energy than the spray pumps do.

Turns out if you start with less water, then heat that smaller amount to a lower temperature, but then spray it around for way longer, you get at least as good a cleaning for less energy.

Anonymous 0 Comments

This may get buried but I had a professor who focused on sustainability and did a study on this exact topic. She found the major reason was that when people did dishes they let the water run the whole time.

When they had people turn the sink off, soap everything up, then turn it back on to rinse off the soap. Or turn it off and on between each use, the sink was either the same or a little more efficient than the dishwasher.

Anonymous 0 Comments

The dishwasher uses the water, heats it up and it uses it to wash the dishes. It’s like when you fill the sink up with water. You don’t empty it it until you’re done washing. The dishwasher will use the same water and then drain it and use new water to rinse the dishes and drain again.

Here is the video showing what is actually happening inside the dishwasher.

Then when it is done, it uses heat to dry the dishes like a dryer.

A dishwasher works the same way a washing machine works but it has a built in dryer too. That is why it uses less water than it does when you do it by hand.

Anonymous 0 Comments

Technology connections has a good video on YouTube that shows the inside working.

Basically they reuse a lot of the water. First it pumps a little water and uses sprayers to get most of the food particles off. They have their own filter and can reuse most of the water. It also does the top and bottom separately so it needs less water total. The machine is also insulated to keep the water hot once it’s heated up. It only replaces the water for the final rinse and steam disinfection cycle. Honestly the heated dry part uses more energy than needed but still less than a water heater.

Compared to a sink which probably takes at least a dozen gallons of hot water to fill up. It takes a lot of energy to heat up that much water. Plus you have to use even more for rinsing. I think the average new dishwasher only uses like 4 gallons for a whole load. So that’s a lot less energy in heating and a lot less water.

Anonymous 0 Comments

How come nobody is mentioning better detergents? Today’s detergents contain enzymes which break down the grease into smaller soluble parts. So the water temp does not need to go up as high, which improves energy efficiency.