How does volume control work in digital devices?
In: Engineering
(without taking human hearing into consideration) “volume” literally refers to the volume of air being displaced by a sound which is more or less proportional to the displacement of a speaker cone (or surface) which is proportional to the peak-to-peak voltage being applied to the electromagnetic coil in the speaker.
phew.
With that said “volume” works by taking an input signal (your music/etc) and mapping it to a range of voltages.
E.g. if -1 .. 1 volts is “100% volume” then for your music the lowest it could move the coil is -1 volts and the highest would be 1 volt (this pushes/pulls the cone of the speaker which creates pressure waves which is what sound is).
At say “50%” the same input signal is mapped to -0.5 volts to 0.5 volts. Meaning the cone travels less distance and displaces less volume of air as a result. In reality the mapping of volume “numbers” you see on screen and voltage ranges is not linear but typically logarithmic.
As for perceived volume … The tricky part though is what you “hear” (your brain perceives) and is happening are not the same thing. Our ears are actually not equally sensitive to all frequencies of sound (distance between peaks in the waves of air). Low frequencies for instance require a lot more energy to be perceived as louder. Whereas frequencies in say the human voice range (200-4000Hz) need less changes in volume to be perceived as being louder/quieter.
As a side note this is how audio compression works. If you’re less sensitive to say sounds in the sub-200Hz range then you don’t need as much *precision* when you encode them. Additionally some frequencies can “mask” others. E.g. a loud 2kHz tone could make you far less able to perceive changes in a parallel 750Hz tone. Additionally our hearing isn’t “real time”. Some loud tones can mask other frequencies that come **before** and **after** them (as in a loud tone could actually mask a quieter tone that happened just before it).
(damn Covid-19 … I’m bored).
The same way it works on analog devices, it increases/decreases the amount of current that makes it to the speaker. This makes it vibrate more or less.
The only difference technically is that digital systems work by steps, while analog is analog. If both had the same arbitrary scale of 1-10 (there is no standard for what a 10 in volume means) then digital generally isn’t programmed to do 8.5, but analog you could set it there.
* There are two ways:
* The first is controlling the amp.
* Sound is analog by nature.
* So every digital audio signal that makes it to your ears is converted to analog at some point.
* When you adjust the “volume” on a device, you are telling the amplifier how much to amplify the signal.
* However, you can also modify the digital version of the signal to have a higher level.
* This is done by simply doing some math with the audio samples.
* So in this scenario, the signal data itself is altered. Then it gets fed into the device that converts it to analog.
Latest Answers